LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Lighting System - Diagnostic Codes & Circuit Tests) >> Lighting System >> DTC B2451: Vehicle Specifications have not been Stored [10/2017 - 09/2019] >> Procedure

DTC B2451: Vehicle Specifications have not been Stored [10/2017 - 09/2019]: Procedure

WARNING: This page is about a different car, the 2019 Toyota C-HR and 2018 Toyota C-HR. However, it is still accessible from the selected car via links, so may be relevant.
  1. VEHICLE INFORMATION HEADLIGHT ECU SUB-ASSEMBLY LH 
    1. Register vehicle information for the headlight ECU sub-assembly LH.

      Refer to INITIALIZATION [10/2017 - 09/2019]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CLEAR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [02/2017 - 09/2019]

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  3

  3. CHECK FOR DTC 
    1. Turn the ignition switch to ON.
    2. Turn on the headlights using the light control switch.
    3. Check for DTCs.

      Refer to DTC CHECK / CLEAR [02/2017 - 09/2019]

      Body Electrical > HL AutoLeveling > Trouble Codes 

      Result

      Result Proceed to
      DTC B2451 output does not occur A
      DTC B2451 output occurs B

    Result: 

    A 

    END (NORMAL AFTER VEHICLE INFORMATION REGISTERED) 

    Result: 

    B 

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2017 - 09/2019]