LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Lighting System - Diagnostic Codes & Circuit Tests) >> Lighting System >> Clearance Light/Daytime Running Light Circuit [10/2017 - 09/2019] >> Procedure

Clearance Light/Daytime Running Light Circuit [10/2017 - 09/2019]: Procedure

WARNING: This page is about a different car, the 2019 Toyota C-HR and 2018 Toyota C-HR. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.
    4. Perform the Active Test according to the display on the Techstream.

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Clearance lights ON or OFF -
      Daytime Running Light Daytime running lights ON or OFF -

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display
      Clearance Light

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display
      Daytime Running Light

      OK

      Clearance lights and daytime running lights illuminate.

      Result

      Result Proceed to
      OK A
      NG (for LH Side) B
      NG (for RH Side) C

    Result: 

    A 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2017 - 09/2019] 

    Result: 

    C 

    See step  3

    Result: 

    B 

    See step  2

  2. REPLACE HEADLIGHT UNIT ASSEMBLY LH 
    1. Replace the headlight unit assembly LH with a new or known good one.
      1. for Halogen Headlight: Refer to REMOVAL [10/2017 - 09/2019]
      2. for LED Headlight: Refer to REMOVAL [10/2017 - 09/2019]
    2. Check that the clearance light LH and daytime running light LH operate normally.

      OK

      Clearance light LH and daytime running light LH operate normally.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (HEADLIGHT UNIT ASSEMBLY LH WAS DEFECTIVE) 

    Result: 

    NG 

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2017 - 09/2019] 

  3. REPLACE HEADLIGHT UNIT ASSEMBLY RH 
    1. Replace the headlight unit assembly RH with a new or known good one.
      1. for Halogen Headlight: Refer to REMOVAL [10/2017 - 09/2019]
      2. for LED Headlight: Refer to REMOVAL [10/2017 - 09/2019]
    2. Check that the clearance light RH and daytime running light RH operate normally.

      OK

      Clearance light RH and daytime running light RH operate normally.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (HEADLIGHT UNIT ASSEMBLY RH WAS DEFECTIVE) 

    Result: 

    NG 

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH. Refer to  REMOVAL [10/2017 - 09/2019]