LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lighting System - Diagnostics - Introduction) >> Lighting System >> Initialization [10/2017 - 09/2019] >> Initialization [10/2017 - 09/2019]

Initialization [10/2017 - 09/2019]

WARNING: This page is about a different car, the 2019 Toyota C-HR and 2018 Toyota C-HR. However, it is still accessible from the selected car via links, so may be relevant.
  1. HEADLIGHT ECU SUB-ASSEMBLY LH INITIALIZATION (for LED Headlight) 
    NOTE:
    • If any of the work in the chart below has been performed, vehicle information registration and initialization of the headlight ECU sub-assembly LH are necessary.
      Performed Work or System Condition Necessary Procedures Link
      Replacement of the headlight ECU sub-assembly LH Vehicle information registration for the headlight ECU sub-assembly LH Refer to INITIALIZATION [10/2017 - 09/2019]
      Initialization of the headlight ECU sub-assembly LH
      Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Initialization of the headlight ECU sub-assembly LH
    • A new headlight ECU sub-assembly LH cannot operate until the vehicle information is registered.
    • After replacing the headlight ECU sub-assembly LH, it is necessary to register the vehicle information and then perform initialization.
    • Even if the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.