DTC U023A: Lost Communication with Front Camera Module [02/2017 - 09/2019]: Procedure
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Trouble Codes.
- Clear the DTCs.
Body Electrical > Main Body > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 2
- CHECK FOR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Trouble Codes.
- Check for DTCs.
Body Electrical > Main Body > Trouble Codes
OK
DTC U023A is not output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2017 - 10/2017] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2017 - 05/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2018 - 09/2019]
Result:
NG
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2017 - 05/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2018 - 09/2019]