DTC B163A: Side Airbag Sensor Assembly No. 2 (LH) [09/2019 - ]: Procedure

1. Turn the ignition switch off.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Floor Side Airbag Sensor RH
   *2	Airbag Sensor Assembly

2. Disconnect the cable from the negative (-) battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. Interchange the floor side airbag sensor LH with RH and connect the connectors.
4. Connect the cable to the negative (-) battery terminal.
5. Clear the DTCs stored in memory.

   Refer to DTC CHECK / CLEAR [09/2019 - ]

   Body Electrical > SRS Airbag > Clear DTCs 

6. Turn the ignition switch off.
7. Turn the ignition switch to ON, and wait for at least 60 seconds.
8. Check for DTCs.

   Refer to DTC CHECK / CLEAR [09/2019 - ]

   Body Electrical > SRS Airbag > Trouble Codes 

   HINT: 

   Codes other than DTCs B162A and B163A may be output at this time, but they are not related to this check.

   Result

   Result	Proceed to
   DTC B163A is output.	A
   DTC B162A is output.	B
   DTCs B162A and B163A are not output.	C

9. Turn the ignition switch off.
10. Disconnect the cable from the negative (-) battery terminal.
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

11. Return the floor side airbag sensor LH and RH to their original positions and connect the connectors.

Result: 

A 

REPLACE AIRBAG SENSOR ASSEMBLY. Refer to  REMOVAL [09/2019 - 08/2020]  , or refer to  REMOVAL [08/2020 - ] 

Result: 

B 

REPLACE FLOOR SIDE AIRBAG SENSOR LH. Refer to  REMOVAL [09/2019 - 08/2020]  , or refer to  REMOVAL [08/2020 - 12/2021]  , or refer to  REMOVAL [12/2021 - ] 

Result: 

C 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2019 - 08/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2020 - ]