Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front door removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Initialize back door lock	Power door lock control system	Refer to INITIALIZATION [02/2017 - ]
	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Refer to INITIALIZATION [02/2017 - 08/2020]
	Memorize steering angle neutral point	Pre-collision system	Refer to INITIALIZATION [02/2017 - 08/2020]
Front door window regulator assembly Front door glass sub-assembly Front door glass run	Initialize Power Window Control System	Auto up and down function Jam protection function Catch protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Window open warning function	Refer to INITIALIZATION [02/2017 - ]

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.