Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the combination meter removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [02/2017 - ] |
| Memorize steering angle neutral point | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [02/2017 - 08/2020] | |
| Pre-collision system |