Washer Fluid Level Warning Switch Circuit [02/2017 - ]: Procedure

1. Remove the level warning switch assembly.

   Refer to REMOVAL [02/2017 - ]

2. Inspect the level warning switch assembly.

   Refer to INSPECTION [02/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE LEVEL WARNING SWITCH ASSEMBLY. Refer to  REMOVAL [02/2017 - ] 

Result: 

OK 

See step  2

1. Disconnect the F4 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the chart below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A26-1 (S) - F4-17 (WLVL)	Always	Below 1 Ω
   A26-1 (S) or F4-17 (WLVL) - Body ground	Always	10 kΩ or higher
   A26-2 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [02/2017 - 08/2020]  , or refer to  REMOVAL [08/2020 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR