Speedometer Malfunction [02/2017 - 10/2017]: Procedure

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [02/2017 - ]

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [02/2017 - 10/2017] 

Result: 

A 

See step  2

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [02/2017 - ]

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  REMOVAL [02/2017 - 08/2020] 

Result: 

A 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	OFF, 0, 40, 80, 120, 160, 200, 240, 280	There is a deviation in the values displayed on the speedometer (Control range → Speedometer display) (1) for Gauge speedometer*1 Reference km/h: 40 → 38.7 to 43.2 80 → 79.3 to 84.3 120 → 120.3 to 125.3 200 → 202.1 to 207.1 (2) for Gauge speedometer*2 Reference mph: 40 → 39.5 to 42.3 80 → 80.2 to 83.4 120 → 121.2 to 124.4

   1. *1: w/o Daytime Running Light OFF function
   2. *2: w/ Daytime Running Light OFF function

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Speed Meter Operation

   OK

   Speedometer indication is normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU). Refer to  REMOVAL [02/2017 - 09/2019] 

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [02/2017 - 08/2020]