Meter Illumination is Always Dark [02/2017 - 09/2019]: Procedure

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [02/2017 - 10/2017] , or refer to DIAGNOSIS SYSTEM [10/2017 - 05/2018] , or refer to DIAGNOSIS SYSTEM [05/2018 - 09/2019]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [02/2017 - 05/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [05/2018 - 09/2019] 

Result: 

A 

See step  2

1. Check if lighting system DTCs are output.

   Refer to DTC CHECK / CLEAR [02/2017 - 09/2019]

   Body Electrical > Main Body > Trouble Codes 

   Result

   Result	Proceed to
   DTC B1244 is not output.	A
   DTC B1244 is output.	B

Result: 

B 

GO TO DTC B1244. Refer to  DTC B1244: Light Sensor Circuit Malfunction [02/2017 - 09/2019] 

Result: 

A 

See step  3

1. Replace the combination meter assembly.

   Refer to REMOVAL [02/2017 - 08/2020]

   OK

   The operation of the combination meter assembly returns to normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [02/2017 - 10/2017]  , or refer to  REMOVAL [10/2017 - 08/2020]