DTC C146E: Open Circuit in ABS Solenoid Relay Circuit [04/2018 - 08/2021]: Procedure

1. Replace the skid control ECU (brake actuator assembly).

   Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 08/2021]

   HINT: 

   This DTC is output when the skid control ECU (brake actuator assembly) detects a malfunction in an internal circuit.

2. Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Utility / Test Mode.
3. Perform system variant learning and acceleration sensor zero point calibration.

   Refer to CALIBRATION [04/2018 - 08/2021]

   Chassis > ABS/VSC/TRAC/EPB > Utility 

   Tester Display
   Test Mode

4. Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Utility / Signal Check.
5. Perform the sensor check using the Test Mode (Signal Check) procedure.

   Refer to TEST MODE PROCEDURE [04/2018 - 08/2020] , or refer to TEST MODE PROCEDURE [08/2020 - 08/2021]

   Chassis > ABS/VSC/TRAC/EPB > Utility 

   Tester Display
   Signal Check

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END