Caution / Notice / Hint
NOTE:
- When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.
Refer to CALIBRATION [04/2018 - 08/2021]
- Inspect the fuses for circuits related to this system before performing the following procedure.
HINT:
When C1241 and/or C1417 is output together with C146C, inspect and repair the trouble areas indicated by C1241 and/or C1417 first.
for C1241: Refer to DTC C1241: Low or High Power Supply Voltage [04/2018 - 08/2020] , or refer to DTC C1241: Low or High Power Supply Voltage [08/2020 - 08/2021]
for C1417: Refer to DTC C1417: IG1 Voltage Supply too High [04/2018 - 08/2020] , or refer to DTC C1417: IG1 Voltage Supply too High [08/2020 - 08/2021]