LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Avalon Touring >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> EXTERIOR PANELS / TRIM (SERVICE INFORMATION) (1 Of 2) >> Roof Drip Side Finish Moulding >> Removal [04/2018 - ] >> Procedure

Removal [04/2018 - ]: Procedure

  1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING 
    1. Apply protective tape around the center roof drip side finish moulding as shown in the illustration.
      GTY858057Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape - -
    2. Using a moulding remover, disengage the 2 clips and remove the center roof drip side finish moulding.
      GTY868182Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Do not remove the No. 1 roof drip side finish moulding clips.
      • If a No. 1 roof drip side finish moulding clip is damaged or falls off, replace it with a new one.
scientia non olet · About LEMON Manuals