LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Avalon TRD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Service Information) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [04/2018 - 08/2020] >> Procedure

Removal [04/2018 - 08/2020]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2018 - ]

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for HV Model) 

    Refer to PROCEDURE - Step 2 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 2 [08/2019 - 08/2021]

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    for A25A-FKS:

    Refer to PROCEDURE - Step 3 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 3 [08/2019 - 08/2021]

    for 2GR-FKS:

    Refer to PROCEDURE - Step 2

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If an airbag deploys for any reason, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE SPARE WHEEL COVER ASSEMBLY (for Gasoline Model) 

    w/ Seat Heater System:

    Refer to PROCEDURE - Step 1

  5. REMOVE LUGGAGE COMPARTMENT INNER TRIM PAD (for Gasoline Model) 

    w/ Seat Heater System:

    Refer to PROCEDURE - Step 5

  6. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Gasoline Model) 

    Refer to PROCEDURE - Step 7

  7. REMOVE REAR SEAT CUSHION ASSEMBLY (for Gasoline Model) 

    Refer to PROCEDURE - Step 8

  8. REMOVE REAR SEAT CUSHION LOCK HOOK (for Gasoline Model) 

    Refer to PROCEDURE - Step 9

  9. REMOVE FRONT DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 3

  10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the front door opening trim weatherstrip.
  11. REMOVE REAR DOOR SCUFF PLATE (for Gasoline Model) 

    Refer to PROCEDURE - Step 7

  12. REMOVE REAR DOOR SCUFF PLATE (for HV Model) 

    Refer to PROCEDURE - Step 8

  13. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the rear door opening trim weatherstrip.
  14. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the 3 claws to remove the lap belt outer anchor cover.
      GTY863018Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
      GTY863023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE CENTER PILLAR LOWER GARNISH 

    Refer to PROCEDURE - Step 12

  17. REMOVE CENTER PILLAR UPPER GARNISH 

    Refer to PROCEDURE - Step 13

  18. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
      GTY863025Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.
      GTY866450Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Locking Button
      *c Release

      HINT: 

      Tape the screwdriver tip before use.

    3. Remove the 2 bolts.
      GTY862956Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 guides to remove the front seat outer belt assembly.
  19. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 
    1. Remove the 2 bolts.
      GTY862949Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.
scientia non olet · About LEMON Manuals