LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Avalon TRD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 96 (Transfer Case (Service Information)) >> Transfer Assembly >> Removal [08/2020 -] >> Procedure

Removal [08/2020 -]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [08/2020 -]

  2. REMOVE PROPELLER SHAFT HEAT INSULATOR 

    Refer to PROCEDURE - Step 19

  3. REMOVE NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY 
    1. Remove the 2 bolts and No. 1 propeller shaft heat insulator bracket sub-assembly from the transfer assembly.
      GTY934333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  5. REMOVE TRANSFER ASSEMBLY 
    1. Remove the 8 nuts and transfer assembly from the automatic transaxle assembly.
      GTY869846Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals