LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Avalon TRD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 58 (Starting System (Service Information) [A25A-FKS]) >> Starter >> Removal [08/2020 - ] >> Procedure

Removal [08/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2018 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE FRONT ENGINE MOUNTING INSULATOR 

    Refer to REMOVAL [08/2020 - ]

  4. REMOVE FLYWHEEL HOUSING SIDE COVER 
    1. Disengage the claw as shown in the illustration to remove the flywheel housing side cover.
      GTY948015Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter assembly connector.
      GTY958495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Open the terminal cap.
    3. Remove the nut and disconnect the No. 2 engine wire from terminal 30.
      GTY957510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.
      GTY958479Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals