Removal [08/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
Refer to REMOVAL [08/2020 - ]
REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 8
REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 9
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 10
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 11

REMOVE FRONT ENGINE MOUNTING INSULATOR

Disengage the 4 clamps to separate the radiator hose, vacuum hoses and No. 2 engine wire from the No. 1 radiator bracket.

GTY948629

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and No. 1 radiator bracket from the front engine mounting bracket.

GTY948406

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 2 clamps to separate the vacuum hoses from the front engine mounting insulator.

GTY948637

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the vacuum hose from the front engine mounting insulator.

GTY948740

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Support the engine assembly with transaxle using a jack and wooden block.

GTY948724

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wooden Block Placement Location

Remove the 4 bolts and front engine mounting bracket.

GTY948738

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 3 nuts and front engine mounting insulator from the front frame assembly.

GTY754280

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the nut and stay from the front engine mounting insulator.

GTY948335

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002