Removal [08/2021 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE STEERING WHEEL ASSEMBLY
Refer to REMOVAL [08/2021 - ]
- REMOVE STEERING PAD SWITCH ASSEMBLY
Refer to PROCEDURE - Step 2
- REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
- Remove the 2 screws.
- Disengage the 4 claws.
- Disengage the 2 clamps to disconnect the shift paddle switch (transmission shift switch assemby) from the steering wheel assembly.
- Disconnect the No. 1 transmission shift switch assembly connector and No. 2 transmission shift switch assembly connector to remove the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly from the No. 1 switch wire.
*1 No. 1 Transmission Shift Switch Assembly *2 No. 2 Transmission Shift Switch Assembly
- Remove the 2 screws.
- REMOVE NO. 1 SWITCH WIRE
HINT:
Perform this procedure only when replacement of the No. 1 switch wire is necessary.