Wireless Charger Illumination Circuit [04/2018 - ]: Procedure

1. Disconnect the G12 mobile wireless charger cradle assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   G12-10 (TAIL) - Body ground	Taillight off	Below 1 V
   	Engine switch off, taillight on	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Disconnect the G16 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G16-1 (ILL-) - G12-9 (ILL-)	Always	Below 1 Ω
   G16-1 (ILL-) or G12-9 (ILL-) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [04/2018 - ]  

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR