Engine Oil Pressure Switch Circuit [04/2018 - ]: Procedure

1. Inspect the engine oil pressure switch assembly.

   Refer to INSPECTION [04/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY. Refer to  REMOVAL [04/2018 - ] 

Result: 

OK 

See step  2

1. Disconnect the G16 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C36-1 - G16-9 (S)	Always	Below 1 Ω
   C36-1 or G16-9 (S) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR