Removal [08/2021 - ]: Procedure

REMOVE COOL AIR INTAKE DUCT SEAL

Remove the 7 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the guide and remove the cool air intake duct seal as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Remove in this Direction (1)
	Remove in this Direction (2)

REMOVE FRONT BUMPER ASSEMBLY

Apply protective tape around the front bumper assembly as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Remove the 2 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure for the RH side and LH side.

Remove the screw.

HINT:

Use the same procedure for the RH side and LH side.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 8 screws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 4 claws as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

Disconnect the connector.

*A	w/ Intuitive Parking Assist System

Remove the 4 bolts.

Disengage the 2 guides to remove the front bumper assembly as shown in the illustration.

Remove in this Direction