Inspection [04/2018 -]: Procedure
- INSPECT LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY
- Check the switch.
*a Component without harness connected
(Luggage Compartment Door Opening Switch Assembly)- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 2 - 5 Pressed (On) Below 25 Ω 2 - 5 Not pressed (Off) 1 MΩ or higher If the result is not as specified, replace the luggage compartment door opening switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the switch illumination.
- Apply auxiliary battery voltage to the switch connector and check that the luggage compartment door opening switch assembly illuminates.
OK
Auxiliary Battery Connection Specified Condition Auxiliary battery positive (+) → Terminal 6
Auxiliary battery negative (-) → Terminal 1Illumination illuminates If the result is not as specified, replace the luggage compartment door opening switch assembly.
- Apply auxiliary battery voltage to the switch connector and check that the luggage compartment door opening switch assembly illuminates.
- Check the switch.