Removal [08/2021 - ]: Caution/Notice/Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front television camera assembly, front bumper assembly or radiator grille	Television camera view adjustment Television camera assembly optical axis adjustment (Back camera position setting)*	Panoramic View Monitor System	Refer to INITIALIZATION [04/2018 - ] for Initialization Refer to CALIBRATION [04/2018 - ] for Calibration
Front bumper assembly	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intelligent Clearance Sonar System Intuitive Parking Assist System	Refer to CALIBRATION [04/2018 - ]
Radiator shutter assembly	Change grille shutter control mode and/or perform initialization	Grille Shutter System	Refer to INITIALIZATION [08/2021 - ]

*: Applies only for when removing and installing or replacing the television camera assembly.