Installation [04/2018 - 08/2020]: Procedure

INSTALL COMBINATION METER ASSEMBLY

Connect the 2 connectors.
Engage the clamp.

Engage the 2 clips as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

Install the combination meter assembly with the 3 screws.

INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 25
INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Refer to PROCEDURE - Step 26
INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 30
INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 44
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 31
INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Refer to PROCEDURE - Step 7
INSTALL CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 41
INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 42
INSTALL CONSOLE BOX BEZEL
Refer to PROCEDURE - Step 3
INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
INSTALL CONSOLE BOX POCKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
INSTALL FRONT CONSOLE UPPER PANEL GARNISH
Refer to PROCEDURE - Step 9
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL RH
Refer to PROCEDURE - Step 10
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH
Refer to PROCEDURE - Step 11
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [04/2018 - 08/2020]
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)
Refer to PROCEDURE - Step 18