DCM Communication Stop Mode [04/2018 - 08/2020]: Procedure

1. Disconnect the cable from the negative (-) battery terminal.
2. Disconnect the G9 DCM (telematics transceiver) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G9-15 (CANP) - G9-16 (CANN)	Cable disconnected from negative (-) battery terminal	54 to 69 Ω

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to DCM (Telematics Transceiver))

   Result

   Result
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (DCM (TELEMATICS TRANSCEIVER)) 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G9-4 (E) - Body ground	Cable disconnected from negative (-) battery terminal	Below 1 Ω

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to DCM (Telematics Transceiver))

2. Reconnect the cable to the negative (-) battery terminal.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   G9-1 (+B) - Body ground	Always	11 to 14 V
   G9-7 (IG2) - Body ground	Engine switch on (IG)	11 to 14 V
   G9-8 (ACC) - Body ground	Engine switch on (ACC)	11 to 14 V

   Result

   Result
   OK
   NG

Result: 

OK 

REPLACE DCM (TELEMATICS TRANSCEIVER). Refer to  REMOVAL [04/2018 - 08/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)