Open in One Side of Bus 1 Branch Line [08/2021 -]: Procedure
- CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH LINE
- Based on the vehicle equipment and specifications, confirm the systems that use CAN communication.
Refer to DIAGNOSIS SYSTEM [08/2021 -]
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Using the Techstream, perform "CAN Bus Check".
CAN Bus Check
- Observe the screen for approximately 2 minutes to check for ECUs and sensors that are displayed as not communicating.
- Perform the inspection as specified in the Problem Symptoms Table for the ECUs or sensors that are not communicating.
Result
Proceed to NEXT
Result:
NEXT
GO TO CORRESPONDING COMMUNICATION STOP MODE. Refer to PROBLEM SYMPTOMS TABLE [08/2021 -]
- Based on the vehicle equipment and specifications, confirm the systems that use CAN communication.