DTC B1675: Rear Floor Airbag Sensor [08/2019 - ]: Procedure

1. Turn the ignition switch off.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. Temporarily replace the rear floor side airbag sensor with a new one.
4. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
5. Turn the ignition switch to ON, and wait for at least 60 seconds.
6. Clear the DTCs stored in memory (Refer to DTC CHECK / CLEAR [08/2019 - ] ).
7. Turn the ignition switch off.
8. Turn the ignition switch to ON, and wait for at least 60 seconds.
9. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2019 - ] ).

   OK

   DTC B1675 is not output.

   HINT: 

   Codes other than DTC B1675 may be output at this time, but they are not related to this check.

   TEXT IN ILLUSTRATION
   
   

   *1	Rear Floor Side Airbag Sensor
   *2	Airbag Sensor Assembly

Result: 

OK 

REPLACE REAR FLOOR SIDE AIRBAG SENSOR 

(Refer to REMOVAL [08/2015 - ] )

Result: 

NG 

REPLACE AIRBAG SENSOR ASSEMBLY 

(Refer to REMOVAL [08/2015 - ] )