LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> 4Runner TRD Pro >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display - Service Information >> Combination Meter >> Removal [08/2022 - ] >> Procedure

Removal [08/2022 - ]: Procedure

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2022 - ] ).

  2. REMOVE NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 16

  3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 15

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 
    1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.
    2. Place protective tape as shown in the illustration.
      GTY706131Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Protective Tape
    3. Detach the 4 claws.
    4. Detach the 7 clips and remove the finish panel.
      GTY214419Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 4 screws.
      GTY214414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connectors and remove the combination meter.
scientia non olet · About LEMON Manuals