LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> 4Runner TRD Pro >> Repair and Diagnosis >> Electrical >> Gauges >> Interior Panels / Trim - Service Information >> Front Console Box >> Reassembly [08/2015 - 08/2019] >> Procedure

Reassembly [08/2015 - 08/2019]: Procedure

  1. INSTALL TRANSFER POSITION SWITCH (for VF2BM) 

    Refer to PROCEDURE - Step 1

  2. INSTALL TRANSFER POSITION SWITCH (for VF4BM) 

    Refer to PROCEDURE - Step 1

  3. INSTALL NO. 2 BOX BOTTOM MAT (for 2WD) 
    1. Attach the 4 claws to install the No. 2 box bottom mat.
  4. INSTALL FRONT UPPER CONSOLE PANEL GARNISH 
    1. for VF2A:
      1. Attach the 6 claws to install the front upper console panel garnish.
    2. for 2WD, for VF2BM, VF4BM:
      1. Attach the 10 claws to install the front upper console panel garnish.
  5. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for VF2A) 
    1. Attach the 6 claws to install the shifting hole cover sub-assembly.
  6. INSTALL SWITCH BASE 
    1. Install the switch base with the 2 screws.
  7. INSTALL SEAT HEATER SWITCH (w/ Seat Heater System) 

    Refer to PROCEDURE - Step 1

  8. INSTALL BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY 

    Refer to PROCEDURE - Step 1

  9. INSTALL CONSOLE CUP HOLDER BOX 
    1. Install the console cup holder box with the 6 screws.
  10. INSTALL CONSOLE COMPARTMENT DOOR HINGE SUB-ASSEMBLY 
    1. Install the console compartment door hinge sub-assembly with the 4 screws.
    2. Attach the 6 claws to install the console compartment inner door.
    3. Install the 4 screws.
  11. INSTALL CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY 
    1. Install the console compartment door lock sub-assembly with the 2 screws.
  12. INSTALL CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY 
    1. Install the console compartment door sub-assembly with the 6 screws.
  13. INSTALL CONSOLE BOX REGISTER ASSEMBLY 
    1. Attach the 4 claws to install the console box register assembly.
  14. INSTALL CENTER POWER OUTLET SOCKET COVER 

    Refer to PROCEDURE - Step 1

  15. INSTALL NO. 3 POWER OUTLET SOCKET ASSEMBLY 

    Refer to PROCEDURE - Step 2

  16. INSTALL REAR CONSOLE END PANEL 
    1. Connect the 2 power outlet socket assembly connectors.
    2. Attach the 4 clips and 4 claws to install the rear console end panel.
  17. INSTALL NO. 1 POWER OUTLET SOCKET COVER 

    Refer to PROCEDURE - Step 4

  18. INSTALL NO. 1 POWER OUTLET SOCKET ASSEMBLY 

    Refer to PROCEDURE - Step 5

scientia non olet · About LEMON Manuals