DTC C1420: Acceleration Sensor Malfunction [08/2015 - 08/2019]: Procedure

1. Check that the yaw rate and acceleration sensor is installed properly (Refer to INSTALLATION [08/2015 - 08/2019] ).

   OK

   The sensor is tightened to the specified torque.

   The sensor is not installed at an angle.

Result: 

NG 

INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY 

(Refer to INSTALLATION [08/2015 - 08/2019] )

Result: 

OK 

See step  2

1. Replace the yaw rate and acceleration sensor (Refer to REMOVAL [08/2015 - 08/2019] ).
   NOTE:

   Check the yaw rate and acceleration sensor signal after replacement (Refer to TEST MODE PROCEDURE [08/2015 - 08/2019] ).

Result: 

NEXT 

END