Crawl Indicator Light does not Come ON [08/2015 - 08/2019]: Procedure

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] ).

   OK

   CAN Bus Check indicates no malfunctions in CAN communication.

Result: 

NG 

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )

Result: 

OK 

See step  2

1. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019] )

Result: 

A 

See step  3

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Enter the following menus: Body Electrical / D-SEAT SW / Data List.
   D-SEAT SW
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Crawl Control Main Switch	Crawl control switch/ ON or OFF	ON: Crawl switch on OFF: Crawl switch off	-

   OK

   The Techstream displays ON or OFF according to crawl control switch operation.

Result: 

NG 

See step  5

Result: 

OK 

See step  4

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
   ABS/VSC/TRAC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Crawl Control Light	Crawl control indicator light/ ON or OFF	ON: Indicator light on OFF: Indicator light off	-

6. When performing the Crawl Control Light Active Test, check Crawl Control Light in the Data List (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Crawl Control Light	Crawl control indicator light	Indicator light ON/OFF	Observe the combination meter.

   RESULT
   
   

   Result		Proceed to
   Data List Display	Data List Display when Performing Active Test ON/OFF Operation
   ON	Does not change between ON and OFF	A
   	Changes between ON and OFF	B
   OFF	Does not change between ON and OFF	A
   	Changes between ON and OFF	B

Result: 

A 

REPLACE MASTER CYLINDER SOLENOID 

(Refer to DISASSEMBLY [08/2015 - ] )

Result: 

B 

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )

Refer to PROCEDURE - Step 10

Result: 

OK 

REPLACE DRIVE MONITOR SWITCH 

(Refer to REMOVAL [08/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR