DTC 43: ABS Control System Malfunction [08/2015 - 08/2019]: Procedure

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Turn the ignition switch off.
3. Turn the ignition switch to ON.
4. Check if an ABS DTC is output (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
   RESULT
   
   

   Result	Proceed to
   DTC (ABS DTC) is not output	A
   DTC (ABS DTC) is output	B

Result: 

B 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019] )

Result: 

A 

See step  2

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Turn the ignition switch off.
3. Turn the ignition switch to ON.
4. Check if the same DTC is output (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )

Result: 

B 

REPLACE MASTER CYLINDER SOLENOID 

(Refer to DISASSEMBLY [08/2015 - ] )