Installation [08/2015 - 08/2019]: Procedure
- INSTALL NO. 2 RADIO BRACKET
- Install the No. 2 radio bracket with the 5 screws.
Torque: 2.5 N*m (25 kgf*cm, 22 in.*lbf)
- Install the No. 2 radio bracket with the 5 screws.
- INSTALL NO. 1 RADIO BRACKET
- Install the No. 1 radio bracket with the 5 screws.
Torque: 2.5 N*m (25 kgf*cm, 22 in.*lbf)
- Install the No. 1 radio bracket with the 5 screws.
- INSTALL HAZARD SWITCH WIRE
- Connect the connector.
- Attach the 2 clamps to install the hazard switch wire.
- INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS
- Connect each connector.
- Insert the navigation receiver assembly with brackets to attach the 6 claws on its backside.NOTE:
When inserting the navigation receiver assembly with brackets, do not press its knobs on it.
- Install the navigation receiver assembly with brackets with the 4 bolts.
Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)
- INSTALL HEATER CONTROL ASSEMBLY
Refer to PROCEDURE - Step 1
- INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 3
- INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 8
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).
- CHECK SRS WARNING LIGHT
(Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] )