Installation [08/2015 - 08/2019]: Procedure

1. Install the No. 2 radio bracket with the 3 screws.

   Torque: 2.5 N*m (25 kgf*cm, 22 in.*lbf) 

1. Install the No. 1 radio bracket with the 3 screws.

   Torque: 2.5 N*m (25 kgf*cm, 22 in.*lbf) 

1. Connect the connector.
2. Attach the 2 clamps to install the hazard switch wire.

1. Connect each connector.
2. Insert the radio and display receiver assembly with brackets to attach the 6 claws on its backside.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   When inserting the radio and display receiver assembly with brackets, do not press its knobs on it.

3. Install the radio and display receiver assembly with brackets with the 4 bolts.

   Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf) 

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 8