Entire Combination Meter does not Operate [08/2019 - ]: Procedure

1. Disconnect the F14 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Rear view of wire harness connector (to Combination Meter Assembly)

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F14-20 (MGND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F14-22 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   F14-21 (B) - Body ground	Always	11 to 14 V

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2015 - 08/2022]  , or refer to  REMOVAL [08/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR