DTC P279E: Four Wheel Drive (4WD) Range Signal Circuit Range / Performance [08/2019 - ]: Description
WARNING: This page is about a different variant/trim than selected.
When the transfer position switch is switched, the 2-4 terminal and LO terminal change to one of the following ON/OFF combinations listed in the table below.
| Terminal | H2 | Between H2 and H4 | H4 | Between H4 and L4 | L4 |
|---|---|---|---|---|---|
| 2-4 | ON | OFF | ON | OFF | OFF |
| LO | OFF | OFF | ON | OFF | ON |
This DTC is detected if the transfer position switch 2-4 terminal and LO terminal signals are simultaneously received.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P279E | Four Wheel Drive (4WD) Range Signal Circuit Range / Performance |
|
|