DTC C0526-96: Steering Angle Sensor Module Component Internal Failure [08/2019 - ]: Procedure

1. Replace the spiral cable sub-assembly.

   Refer to REMOVAL [08/2015 - ]

   NOTE:

   When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.

   HINT: 

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.

   Refer to PROBLEM SYMPTOMS TABLE [08/2019 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END