Replacement [08/2015 - ]: Procedure

REPLACE BRAKE FLUID
1. Turn the engine switch on (IG).
2. Remove the brake master cylinder reservoir filler cap assembly.
3. Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
4. While depressing the brake pedal, loosen the bleeder plug of the front disc brake cylinder RH, and then repeatedly depress the brake pedal.
5. Repeatedly depress the brake pedal until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
  Torque: 11 N.m (110 kgf/cm, 8 ft.lbf)
6. Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
7. With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
  HINT:
  - Air is bled as the pump motor operates while the brake pedal is being depressed
  - Be sure to release the brake pedal to stop the motor after approximately 100 seconds of continuous operation.
  - As brake fluid is continuously drained while the pump operates, it is not necessary to repeatedly depress the brake pedal.
8. Tighten the bleeder plug, and then release the brake pedal.
  Torque: 11 N.m (110 kgf/cm, 8 ft.lbf)
9. Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
10. Turn the engine switch off (IG).
11. Inspect for brake fluid leaks.
12. Check and adjust the brake fluid level (Refer to ON-VEHICLE INSPECTION [08/2015 - ] ).
13. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ] ).