Caution / Notice / Hint
NOTE:
- Bleed air with the shift lever in P and the parking brake set.
- Bleed air while adding fluid to maintain the fluid level between the MIN and MAX lines of the reservoir.
- As brake fluid may overflow when fluid is released from the brake actuator, do not leave the brake fluid can in the reservoir filler opening when adding brake fluid.
- If the brake pedal is depressed with the reservoir cap removed, brake fluid may overflow.
- Do not allow brake fluid to come into contact with any painted surface. If contact occurs, wash off the fluid immediately.
- When the brake fluid is bled, DTCs may be stored. Therefore, after air bleeding, always clear the DTCs and check that a normal system code is output.
- When bleeding air, select the suitable procedure listed below.
Replaced/Installed Item Work Procedure Flexible hose (front/rear) Bleed brake line Disc brake cylinder assembly (front/rear) Brake booster with accumulator pump assembly Bleed brake system Brake master cylinder sub-assembly Brake master cylinder reservoir assembly