DTC C0500-23: Left Front Wheel Speed Sensor Signal Stuck Low; DTC C0506-23: Right Front Wheel Speed Sensor Signal Stuck Low [08/2019 - ]: Description

Refer to DTCs C0500-1F and C0506-1F.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C0500-23	Left Front Wheel Speed Sensor Signal Stuck Low	Any of the following is detected: When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors for 15 seconds or more. When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more. When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, outputs from both front speed sensors are 0 km/h (0 mph) for 15 seconds or more. (except both rear speed sensors are 0 km/h (0 mph))	Front speed sensor LH Front speed sensor rotor LH (Front axle with ABS rotor bearing assembly LH) Sensor installation Front skid control sensor wire LH
C0506-23	Right Front Wheel Speed Sensor Signal Stuck Low	Any of the following is detected: When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors for 15 seconds or more. When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, output from one of the speed sensors is 0 km/h (0 mph) for 1 second or more. When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, outputs from both front speed sensors are 0 km/h (0 mph) for 15 seconds or more. (except both rear speed sensors are 0 km/h (0 mph))	Front speed sensor RH Front speed sensor rotor RH (Front axle with ABS rotor bearing assembly RH) Sensor installation Front skid control sensor wire RH

C0500-23 DTC DETECTION CONDITIONS

		Vehicle Condition
		Pattern 1	Pattern 2	Pattern 3
Diagnosis Condition	When the +BS terminal voltage is 17.4 V or less	◦	◦	◦
Malfunction Status	At a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors	◦	-	-
	At a vehicle speed of 10 km/h (6 mph) or more, output from one of the speed sensors is 0 km/h (0 mph)	-	◦	-
	At a vehicle speed of 10 km/h (6 mph) or more, outputs from both front speed sensors are 0 km/h (0 mph) (except both rear speed sensors are 0 km/h (0 mph))	-	-	◦
Detection Time		15 seconds or more.	1 second or more.	15 seconds or more.
Number of Trips		1 trip	1 trip	1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.

C0500-23 DTC DETECTION CONDITIONS

		Vehicle Condition
		Pattern 1	Pattern 2	Pattern 3
Diagnosis Condition	When the +BS terminal voltage is 17.4 V or less	◦	◦	◦
Malfunction Status	At a vehicle speed of 10 km/h (6 mph) or more, output voltage from one of the speed sensors is less than that from the other sensors	◦	-	-
	At a vehicle speed of 10 km/h (6 mph) or more, output from one of the speed sensors is 0 km/h (0 mph)	-	◦	-
	At a vehicle speed of 10 km/h (6 mph) or more, outputs from both front speed sensors are 0 km/h (0 mph) (except both rear speed sensors are 0 km/h (0 mph))	-	-	◦
Detection Time		15 seconds or more.	1 second or more.	15 seconds or more.
Number of Trips		1 trip	1 trip	1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.