TS and CG Terminal Circuit [08/2015 - 08/2019]: Procedure
- CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - TS of DLC3)
- Turn the ignition switch off.
- Disconnect the A53 skid control ECU (brake actuator assembly) connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition A53-33 (TS) - F13-12 (TS) Always Below 1 Ω A53-33 (TS) or F13-12 (TS) - Body ground Always 10 kΩ or higher
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
See step 5
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- CHECK HARNESS AND CONNECTOR (TS of DLC3 - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F13-12 (TS) - Body ground Always 10 kΩ or higher TEXT IN ILLUSTRATION*a Front view of DLC3
Result:
OK
REPLACE BRAKE ACTUATOR ASSEMBLY
(Refer to REMOVAL [08/2015 - 08/2019] )
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- Measure the resistance according to the value(s) in the table below.