DTC C1433: Steering Angle Sensor Internal Circuit [08/2015 - 08/2019]: Procedure
- REPLACE STEERING ANGLE SENSOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY)
- Replace the steering angle sensor (spiral with sensor cable sub-assembly) (Refer to REMOVAL [08/2015 - ]
).NOTE:
- Do not remove the steering angle sensor from the spiral with sensor cable sub-assembly.
- When replacing the steering angle sensor (spiral with sensor cable sub-assembly), confirm that the replacement part is of the correct specification.
Result:
NEXT
END
- Replace the steering angle sensor (spiral with sensor cable sub-assembly) (Refer to REMOVAL [08/2015 - ]
).