ABS Warning Light does not Come ON [08/2019 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Perform Active Test of the combination meter assembly using the Techstream.
   BODY ELECTRICAL > COMBINATION METER > ACTIVE TEST
   
   

   Tester Display
   Indicat. Lamp ABS

5. Check the combination meter assembly.

   OK

   The ABS warning light turns on or off in accordance with the Techstream.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to  REMOVAL [08/2019 - ] 

Result: 

NG 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]