DTC C146E: Open in ABS Solenoid Relay Circuit; DTC C146F: Short in ABS Solenoid Relay Circuit [08/2019 - ]: Description

The solenoid relay is built into the master cylinder solenoid.

This relay supplies power to each solenoid. If the initial check is OK, after the ignition switch is turned to ON, the relay turns on.

DTC Code	DTC Detection Condition	Trouble Area
C146E	Either condition is met: Both of the following conditions continue for at least 0.2 seconds. IG voltage is between 9.5 and 17 V. The relay contact is open when the relay is on. Both of the following conditions continue for at least 0.2 seconds. IG voltage is 9.5 V or less when the relay is on. The relay contact remains open.	ABS NO. 2 fuse Solenoid relay circuit Master cylinder solenoid
C146F	The following condition continues for at least 0.2 seconds. The relay contact is closed immediately after turning the ignition switch to ON when the relay is off.