LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Supra Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Cooling System (B46) - Service Information) >> RADIATOR HOSE (for Upper Side) >> Removal [07/2020 - ] >> Procedure

Removal [07/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Toyota Supra, 2023 Toyota Supra, 2022 Toyota Supra, and 2021 Toyota Supra. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR 

    Refer to REMOVAL [03/2019 - ]

  2. DRAIN ENGINE COOLANT (for High Temperature) 

    Refer to PROCEDURE - Step 4

  3. REMOVE ENGINE ROOM ECM COVER 
    1. Release snap-lock couplings (1).
      GTY945959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Feed the engine room ECM cover (2) out toward the top and remove.
  4. REMOVE NO. 2 RADIATOR HOSE 
    WARNING:
    • Hot fluids.

      Risk of scalding!

      • Conduct all work in the vehicle wearing appropriate personal protective equipment only.
    NOTE:

    Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

    1. Unlock radiator hose sub-assembly (1) and pull off.
      GTY994805Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Catch and dispose of escaping coolant.
    3. Unlock No. 2 radiator hose (1) and pull off.
      GTY994832Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Catch and dispose of escaping coolant.
    5. Unlock the No. 2 radiator hose (1) below the intake plenum and detach it from the water valve.
      GTY994728Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Catch and dispose of escaping coolant.
    7. Guide the No. 2 radiator hose (1) out and remove.
scientia non olet · About LEMON Manuals