Caution / Notice / Hint
WARNING:
- Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
- Detach the cable from the negative (-) battery terminal.
NOTE:
- Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
- Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
- Antistatic work clothing and antistatic shoes (with ESD symbol).
- For additional information see:
Refer to PRECAUTION [03/2019 - ]
- Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
- When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
- Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
HINT:
- Combination meter assembly must be programed after it is replaced.
For additional information see:
Refer to PRECAUTION [03/2019 - ]