Freeze Frame Data [11/2018 - 10/2023]
WARNING: This page is about a different variant/trim than selected.
- FREEZE FRAME DATA
- Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.
- CHECK FREEZE FRAME DATA
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Back Door / Trouble Codes.
Body Electrical > Back Door
Tester Display Measurement Item Range Normal Condition Diagnostic Note Half Latch SW Latch switch signal ON or OFF ON: Back door lock motor open-latched
OFF: Back door lock motor full-latched or half-latched- Closer Position SW Initial switch signal ON or OFF ON: Back door lock center gear in center position (Initial switch on)
OFF: Back door lock center gear out of center position (Initial switch off)- Pawl Position Switch Pawl switch signal ON or OFF ON: Back door lock motor open-latched
OFF: Back door lock motor except open-latched- Courtesy SW Back door courtesy switch signal ON or OFF ON: Back door open
OFF: Back door closed- Back Door Position Status of the back door position -4000 to 21500 Edge 3000 to 6000 Edge - Back Door Horizontal Torsion Status of the torsion between back door LH and RH -128 to 127 Edge -128 to 127 Edge - Battery Voltage Status of the auxiliary battery voltage 0 to 31 V 11 to 14 V - Closer Control Status Status of the closer control Initialize, "Close 1: Standby", "Close 2: Operate Standby", "Close 3: Operation", "Close 4: Return Standby", "Close 5: Return", "Release 1: Standby", "Release 2: Operation", "Release 3: Return Standby", "Release 4: Return", "Forcible 1: Release Operation", "Forcible 2: Close Standby", "Forcible 3: Close Operation Standby", "Forcible 4: Close Operation", "Forcible 5: Closer Torque Moderate", "Forcible 6: Door Check" or Stop Function Status of the closer control - PBD Control Status Status of the power back door system control All Close Initialize, All Close, "Open 1: Auto Open Standby", "Open 2: Latch Release Standby", "Open 3: Auto Open Operation", All Open, "Close 1: Auto Close Standby", "Close 2: Auto Close Operation", "Close 3: Closer Start Standby", "Close 4: All Close Standby", Neutral, Auto Close Reverse or Brake Status of the power back door system control - #Codes Number of DTCs Min.: 0, Max.: 255 Number of DTCs will be displayed -
- CLEAR FREEZE FRAME DATA NOTE:
Clearing the DTCs will also clear the Freeze Frame Data.
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Clear the DTCs and Freeze Frame Data.