Replacement [11/2018 - 10/2019]: Procedure

Refer to PROCEDURE - Step 11

1. Stop the vehicle on a level surface.
2. Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the transfer filler plug and gasket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Transfer Filler Plug
   *2	Transfer Drain Plug

3. Using a 10 mm hexagon socket wrench, remove the transfer drain plug and gasket and drain the transfer oil.
4. Using a 10 mm hexagon socket wrench, install a new gasket and the drain plug.

   Torque: 39 N.m (398 kgf/cm, 29 ft.lbf) 

1. Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the transfer filler plug and gasket.
   • SST: 09961-00950 
2. Add transfer oil.

   Oil grade

   Toyota genuine differential gear oil LX API GL-5 or equivalent

   Viscosity

   SAE 75W-85

3. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the transfer filler plug hole.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	0 to 5.0 mm (0 to 0.197 in.)

   NOTE:

   • When adding oil, pour it slowly.
   • Add oil a little at a time, waiting several minutes between each addition of oil.
   • Too much or too little oil will lead to transfer problems.

   Standard capacity

   0.37 to 0.44 liters (0.39 to 0.46 US qts, 0.33 to 0.39 Imp. qts)

4. Wait approximately 5 minutes and check that the oil level has not changed.
5. Using SST, 10 mm straight hexagon wrench and union nut wrench, install a new gasket into the transfer filler plug, and then install the transfer filler plug.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	10 mm Straight Hexagon Wrench
   *b	10 mm Union Nut Wrench
   *c	Fulcrum Length

   • SST: 09961-00950 

   Specified tightening torque 

   Torque: 39 N.m (398 kgf/cm, 29 ft.lbf) 

   NOTE:

   After adding oil, drive the vehicle and recheck the oil level (Refer to PRECAUTION [11/2018 - ] ).

   HINT: 

   • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

     ()

   • When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + SST (fulcrum length of 150 mm (5.906 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 19.9 N.m (203 kgf/cm, 15 ft.lbf)

Refer to PROCEDURE - Step 99