Replacement [11/2018 - ]: Procedure

1. Disengage the 3 hooks and separate the hood to cowl top seal from the cowl top ventilator louver sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disengage the 2 claws and 2 guides to remove the center cowl top ventilator louver from the cowl top ventilator louver sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the brake master cylinder reservoir filler cap.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Fill the reservoir with brake fluid.

   Brake Fluid

   SAE J1703 or FMVSS No. 116 DOT3

   SAE J1704 or FMVSS No. 116 DOT4

   NOTE:

   • Make sure that there is sufficient brake fluid in the reservoir.
   • Do not remove the filter from the brake master cylinder reservoir and be sure to fill the brake master cylinder reservoir with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.

1. Remove the bleeder plug cap.
2. Connect a vinyl tube to the bleeder plug.
3. Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1
4. When fluid stops coming out, tighten the bleeder plug and release the brake pedal.*2
5. Repeat steps *1 and *2 until new brake fluid comes out.
6. Tighten the bleeder plug completely.

   Torque: 8.3 N.m (85 kgf/cm, 73 in.lbf) 

7. Install the bleeder plug cap.
8. Repeat the above steps to replace the brake fluid of the brake lines for each wheel.

Refer to ON-VEHICLE INSPECTION [11/2018 - ]

1. Install the brake master cylinder reservoir filler cap.

1. Engage the 2 claws and 2 guides to install the center cowl top ventilator louver from the cowl top ventilator louver sub-assembly.
2. Engage the 3 hooks and install the hood to cowl top seal from the cowl top ventilator louver sub-assembly.