Installation [02/2019 - 08/2020]: Procedure

INSTALL SPARK PLUG
HINT:

Perform "Inspection After Repair" after replacing a spark plug.
- w/ Canister Pump Module:
  Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]
- w/o Canister Pump Module:
  Refer to INITIALIZATION [11/2018 - 08/2020]
1. Install the 4 spark plugs to the cylinder head sub-assembly.
  Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)
  
  NOTE:
  If a spark plug has been struck or dropped, replace it.
INSTALL IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 58